[Elecraft] K2 encoder installation 2018
Scott
netbsd21 at gmail.com
Sun Sep 2 14:56:14 EDT 2018
Looks like I missed Don's earlier response. Sorry for taking up the
bandwidth.
Scott
AD5HS
On 9/2/2018 6:30 AM, Ted Salmon wrote:
> The encoder plus attached PC board is attached to the Front Panel with a lock
> washer and 1/2" hex nut on the encoder shaft. The diameter of the hole on my
> Front Panel was 10 mm as measured with my calipers. The diameter of the
> threaded mount on the encoder is ~ 9 mm while the diameter of the ring at
> the base of the threaded mount is ~ 10 mm. How is the encoder correctly
> mounted by hardware to the inside face of the Front Panel?
>
> I tried 3 methods without success.
<snip>
More information about the Elecraft
mailing list