[Elecraft] P3 Cursors

[Ed gilliland]

Message: 10
Date: Mon, 15 Oct 2018 09:21:36 -0700 (MST)
From: n6hz<psaffren at elecraft.com>
To:elecraft at mailman.qth.net
Subject: Re: [Elecraft] Elecraft P3 Bar Cursor
Message-ID:<1539620496239-0.post at n2.nabble.com>
Content-Type: text/plain; charset=UTF-8

Hi Ed,

Are there magenta and green arrows toward the bottom of the spectrum display?

>>>yes

These indicate where the cursors are relative to your current center frequency. 	

>>>Understood

If  you are in fixed tune mode, you can easily re-center your VFO A cursor by two consecutive long presses of the SPAN/CENTER button.

>>>In Fixed Tune Mode, two consecutive long presses of the SPAN/CENTER button didn't help.  Green and Magenta arrows are still at the bottom left of the display	
										
If all else fails, a memory reset can be performed by holding down the MENU
button while powering up the P3.  Note that this will erase an function key
settings.

>>>I did a memory reset.  The green and magenta arrows are still at the bottom left of the display.
>>>I reloaded all firmware with the latest versions.  The Green and Magenta arrows are still at the bottom left of the display.

>>>The P3 seems to be working with the exception of the U and BAR cursors.

Ed