[Elecraft] KPA500 Clicks & Pops

[Bill Johnson]

I did a FT on the device and never an issue.  Building requires a bit of electro mechanical skills that some do not have.  When I read the issues, I wonder about how it was built or modified.

73,
Bill
K9YEQ

https://wrj-tech.com/

-----Original Message-----
From: elecraft-bounces at mailman.qth.net <elecraft-bounces at mailman.qth.net> On Behalf Of Dennis Moore
Sent: Tuesday, October 16, 2018 4:14 PM
To: Elecraft Reflector <elecraft at mailman.qth.net>
Subject: Re: [Elecraft] KPA500 Clicks & Pops

I rarely hear anything from my KPA500-F. Serious question, I wonder if those with the kit experience more noise than those with factory assembled units?

Dennis NJ6G


On 10/14/2018 19:52, Bob McGraw K4TAX wrote:
> What is the recommended solution to stopping the clicks and pops from 
> the KPA500 as the amp heats during transmission and cools during 
> receive?  I've seen one that suggested replacing the screws in the Z 
> bracket with 4-40 x 1/4".    Any traction to this?
>
> The amp performs absolutely fantastic.  The clicks and pops are more 
> annoying when working high duty cycle modes.
>
> Thanks in advance.
>
> 73
>
> Bob, K4TAX
>
> KPA500 s/n 3519

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html Message delivered to k9yeq at live.com