[Elecraft] Elecraft P3 Bar Cursor

[n6hz]

Hi Ed, 

Are there magenta and green arrows toward the bottom of the spectrum
display?  These indicate where the cursors are relative to your current
center frequency.   If  you are in fixed tune mode, you can easily re-center
your VFO A cursor by two consecutive long presses of the SPAN/CENTER button.  

If all else fails, a memory reset can be performed by holding down the MENU
button while powering up the P3.  Note that this will erase an function key
settings. 

73, 

Paul


Ed Gilliland wrote
> My P3 cursors have disappeared.  The menu selections are there but the 
> cursors do not appear when selected.  I have the latest P3 firmware
> loaded.
> 
> Ed W5TM
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:

> Elecraft at .qth

> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to 

> lists+1215531472858-365791 at .nabble





--
Sent from: http://elecraft.365791.n2.nabble.com/