[Elecraft] K3 - Loss of Output

[Don Wilhelm]

Tom,

The PA voltage connector pin problem will normally result in an ERR 12V 
message.

It sounds like something has just gotten "mixed up".

Do you have a saved configuration file for that K3?  If so, you may want 
to try doing a Reset to Factory Defaults (EEINIT)and then restore the 
configuration file from K3 Utility.  If you do not have a saved 
configuration file, you will have to install all the options manually 
and go through the calibration procedures.

73,
Don W3FPR

On 10/10/2018 7:32 AM, Tom Lizak wrote:
> Hi Gang,
> 
>   
> 
> Was doing the New England WX Net this AM on 75m and all of a sudden, NO
> OUTPUT...hmmm!
> 
>   
> 
> I put it into PA By-pass and still nothing.  I can hear the tone in another
> RX whether on PA or by-pass but NADA on the watt meter.
> 
>   
> 
> Before I send it to the "Mother Ship", I was wondering if this could be the
> infamous PA connector pin issues ?  PA temp @ 25C which is ambient temp of
> the room ATM.
> 
> K3 s/n 00184.
> 
>   
> 
> HELP !
> 
> 73
> 
> Tom/K1TL...
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to donwilh at embarqmail.com
>