[Elecraft] CODEC

[Jeff Stai]

I bet Mike would appreciate getting back to his issue, which has nothing to
do with VOX...

Are you using a high end sound card/CODEC? If so it may just be that the
internal CODEC - while quite good - is not up to snuff for this
application.

I'd also try using different USB cables, though that doesn't sound like it
would be the problem.

73 jeff wk6i

On Mon, Oct 1, 2018 at 8:49 AM, Mike Greenway <K4PI at bellsouth.net> wrote:

> I have used for years a K3 on EME with WSJT using Line In/Out audio.
> Recently got a K3S and I am now using USB (CODEC) audio in and out of the
> radio.  In WSJT-10 they have Rate In/Rate Out monitors that should normally
> run at 1.000. Using the K3 analog audio these always stayed right on 1.000
> but now that I am using the USB audio they are jumping around quite often
> and getting out of range indicated in WSJT with a red marker.  I have tried
> two different computers and the same result.  I tried changing the sample
> rate in the computer audio settings but no change in the problem.  I plan
> to go back to analog Line In/Out on the K3S unless someone has an idea on
> how to settle down the Rate In/Out fluctuations.  I have not found anything
> in the K3S that might affect this.  You can reply off line if you like.  73
> Mike K4PI
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to wk6i.jeff at gmail.com
>



-- 
Jeff Stai ~ WK6I ~ wk6i.jeff at gmail.com
Twisted Oak Winery ~ http://www.twistedoak.com/
Facebook ~ http://www.facebook.com/twistedoak
RTTY op at W7RN