[Elecraft] CODEC

[Rick WA6NHC]

Presuming Windows 10 (previous flavors are similar):

1)  Right click the speaker icon, lower right; select "Open Sound Settings"
2)  When that panel opens, click on "Sound Control Panel"
3)  In playback or recording tab, select the device you want to change 
by double clicking it
4)  In the advanced tab of that device; change the default format to 
single/dual channel(s) and the bit rates desired.
5)  Ok your way back out, done.
6)  Report back to the group.

Mine are all defaulted to two audio channels, even though the mic inputs 
are typically mono only.  What I've found is that the software for 
decoding digital modes, isn't usually refined enough to listen to two 
channels of audio, or just one channel of choice, so dual decoding (one 
channel per receiver) is a challenge.  That isn't often needed for me, 
so it's not a huge issue.

73,
Rick NHC


On 10/2/2018 6:32 AM, Ed W0YK wrote:
> There must be a way to correct this, but I haven't found it.
> 73,Ed W0YK
> -------- Origi