[Elecraft] KX3. Get N/A in vfo B display when i tap CMP.

[Don Wilhelm]

Brian,

The "+" in the USB/LSB indicates that ESSB mode is turned on.
Turn it off and you will have compression back.

73,
Don W3FPR

On 11/24/2018 4:04 PM, Brian “VE3BWP” Pietrzyk wrote:
> I’ve recently discovered that when I try to enable TX compression by tapping the CMP button I just get “N/A” in the VFO B display. The CMP icon does not show. I am able to toggle the S meter to CMP/ALC by tapping the MIC/KEY button no problem.
> 
> I do see a + icon show on USB/LSB as i cycle through the modes
> 
> I searched the reflector archive and the closest mention I find was changing from SSB + CW to - CW. I also made sure the spilt is off. No change.
> 
> Compression used to work fine so it must be some settings conflict I’ve yet to discover.
> 
> Help!
> 
> Thanks,
> 
> Brian ve3bwp
> 
> KX3 s/n 09244
> Firmware:
> Uc 2.90
> Dsp 01.52
> Pa 01.39
> 
> Thanks ve3bwp
> 
> 
> Sent from my iPhone
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to donwilh at embarqmail.com
>