[Elecraft] K3 + SDRPlay's RSP1 as panadaptor

[Don Wilhelm]

Drew,

Your subject line indicates that you are using SDRPlay as a panadapter, 
and in that case, you would want to connect it to the K3 IF OUT and tune 
it to the K3 1st IF of 8.215 MHz.  The display will show you what is in 
the K3 IF.

If instead you are using it as a sub-receiver, you would connect it to 
the K3 RX IN and OUT, or use a separate RX antenna on SDRplay.

Two entirely different uses of SDRplay.

73,
Don W3FPR

On 11/13/2018 5:41 PM, Drew AF2Z wrote:
> I just got a RSP1A and am missing something here: if I connect my 
> receive antenna to the K3 RX In, then connect the K3 RX Out to the SDR, 
> what is the use of the tee?
>