[Elecraft] K3 + SDRPlay's RSP1 as panadaptor

[Drew AF2Z]

I just got a RSP1A and am missing something here: if I connect my 
receive antenna to the K3 RX In, then connect the K3 RX Out to the SDR, 
what is the use of the tee?

73,
Drew
AF2Z




On 11/08/18 10:19, John Simmons wrote:
> Isaac,
> 
> I did exactly that, using the HDSDR software. I used the RX ANT output 
> (must activate it from the front panel of the K3) to feed the antenna of 
> the RSP1. You use a BNC tee to feed the antenna back into the K3. 
> Purists use an RF splitter instead of a tee. I have a YouTube video that 
> shows the results: https://www.youtube.com/watch?v=KusmkeLdfwE
> 
> If you need further help, let me know.
> 
> 73,
> -John NI0K
> TL_Netvision wrote on 11/8/2018 8:22 AM:
>> Hello all,
>>
>> I am considering using an RSP1 SDR with my K3. I will probably use HDSDR
>> software to start with.
>> Can someone point me in the right direction for the whole procedure?
>>
>> TIA
>> Isaac, 4Z1TL
>>
>>
>> ---
>> This email has been checked for viruses by Avast antivirus software.
>> https://www.avast.com/antivirus
>>
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>>
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>> Message delivered to jasimmons at pinewooddata.com
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to pubx1 at af2z.net
>