[Elecraft] KX3 out of band TX inhibit

[Ken G Kopp]

Hi Oliver,

Probably the best protection for you is your knowledge of the Part 97 rules
you professed to know to qualify for your license.

73 !

K0PP

On Wed, Nov 7, 2018, 19:06 orbarrett <hoosac19 at hotmail.com wrote:

> Hi all,
>
> Several years back there were discussions about how to limit KX3 transmit
> capability to the regional ham bands applicable to a KX3 user.  As a USA
> user, I wanted to revisit this topic to see if my recent firmware (v. 2.76)
> allows enforcement of these limits.  On page 42 of the KX3 manual, there is
> a reference to the BND END message that is supposed to appear if I transmit
> out of the ham band in my radio, however it puts out full power in CW mode
> (using a dummy load) at 2.5 MHz for example with no displayed message.  I
> can use the TX Inhibit control line (via the ACC2 connector) to prevent TX,
> but would also like software enforcement.
>
> Could someone please clarify whether ham band TX enforcement is available
> for my KX3?
> Oliver Barrett KB6BA
>
>
>
>
>
> --
> Sent from: http://elecraft.365791.n2.nabble.com/
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to kengkopp at gmail.com
>