[Elecraft] Alignment procedure for K2 ser#~2700

[Martin]

Elecrafters,
i successfully installed the 60m-Module, i have rx and tx.
The qso-partners tell me my modulation is very high pitched and 
therefore almost unreadable. Also, the frequency readout is offset by 
almost 400hz. I haven't used the K2 for a very long time , so i think a 
realignment from the start is a good idea.
Unfortunatelly i'm not at home and have no access to the manual. On the 
elecraft website i can only find a manual for K2 with ser#4000 or 
younger. Can anyone point me to an old manual for a K2 ser#2706 revision 
A board, built in 2001?
Thanks.

-- 

73, Martin

Ohne CW ist es nur CB...