[Elecraft] Re K3 Audio

[Nr4c]

Don’t forget that rear Mic is not same as Lin In!

Sent from my iPhone
...nr4c. bill


> On Mar 31, 2018, at 8:14 AM, Richard Ferch <ve3iay at gmail.com> wrote:
> 
> I suspect that what you most likely need is for Line In to be used during
> digital mode operation (with the microphone muted), and the microphone to
> be used during voice mode operation.
> 
> The audio input settings for voice modes and digital modes are stored
> independently, so this is easy. With the radio in SSB, you set MIC SEL to
> wherever your microphone is plugged in, with the appropriate bias and level
> settings. With the radio in DATA A or AFSK A mode, set MIC SEL to LINE IN
> and adjust the Mic gain control to get the required 4-5 bars of ALC meter
> reading in digital modes.
> 
> The only reason you might need MIC+LIN to be set to ON is if you were using
> the computer sound card as a digital voice keyer in voice modes, in which
> case you might want both microphone and line in to be active while
> operating in voice modes. In this case, set MIC+LIN to ON with the radio in
> SSB, and OFF with the radio in DATA A or AFSK A.
> 
> In both cases, you will only need to set this up once; the settings are
> remembered independently in the two modes from then on.
> 
> 73,
> Rich VE3KI
> 
> W7HSG wrote:
> 
> Does any one know the command for both Mike in Front Panel and Line in rear
> panel?
> 
> I need both at the same time,  Mike for voice and Line in for digital.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to nr4c at widomaker.com