[Elecraft] krc2 jumpers setting ..help

[Robert Bajuk]

Hi Noel,

I can share my settings which work just fine with TS480 (it should work
also with TS590 models)... N1MM talks just fine with the radio with KRC in
the middle

You need some small modification inside KRC2.... Here are the settings for
19200 baud-rate

Jumpers IN: 3, 6, 8, 9, 10, and 21, 22, 23
Jumpers 14 & 17 bridged with voltage from pin 7 of U2 fed to this jumper
(~2" piece of wire).

Hope it will solve your problem, try it and report back

73 Robert, S57AW


On Tue, Mar 27, 2018 at 10:12 PM, NOEL POULIN <ve2fww at globetrotter.net>
wrote:

> Hi,
> I am having a hard time with the KRC2 band decoder jumper settings for a
> KENWOOD TS590SG..
> Here is my setting according to the KRC2 manual (page 23)..for kenwood
> radio pc logging in use, data  rate 19200 bps
> INSTALLED REMOVED
> w3,w6,w8                                               w1,w2,w7,w11,
> w12,w13,w14,w15,w16,w17,w18,w19,w20
> w9,w10,w21,w22,w23.
> No luck with settings......
> The logging software is talking to the radio when the decoder is not
> between the radio and the pc....but when I connect the KRC2, no results,
> the logging software can't talk to the radio at all....
>
> What have I done wrong ???
> Help will be more than welcome...
> Many thanks
> Noel
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to rbajuk at gmail.com