[Elecraft] K3 internal connectors

[Brian Hunt]

My K3 is also from 2010, April as I recall. I recently did the component mods you mentioned except for the KREF3 and KPOD resistors. Also I added the general coverage BPF board with 472 kHz in mind. I added the new synthesizer as soon as it came out. It all went very well and only took a few hours, stretching it out to prolong the fun of getting my fingers into my factory built K3. :-)

Add to your list the suggested thermal pads under the LPA transistors. These are recommended if you do a lot of 100% duty cycle transmitting. 

Good luck & 73,
Brian, K0DTJ

> On Mar 23, 2018, at 06:53, ke9uw <c-hawley at illinois.edu> wrote:
> 
> My K3 was purchased in 2010 which seems to avoid most of the early required
> mods. 
> 
>