[Elecraft] K3 internal connectors

[Don Wilhelm]

The best and easiest way to remove the front panel pins is to cut the 
plastic strip on the pins into small enough pieces so you can pull the 
strip off the pins - then remove the pins one at a time.  Clean up with 
solder wick, and if solder remains in the holes, heat the solder pad and 
push it out with a wooden toothpick or a stainless steel needle.

73,
Don W3FPR

On 3/22/2018 2:36 PM, GRANT YOUNGMAN wrote:
> The connectors are not difficult to replace.
> 
> I know that some folks have had issues.