[Elecraft] KPA500 Curiosity Question

[Phil Hystad]

Thanks to those who answered my questions.  Quick response on ye olde electraft group.

73, phil


> On Mar 22, 2018, at 9:22 AM, Phil Hystad <phystad at mac.com> wrote:
> 
> Is there a published circuit diagram of the KPA500, in particular the power supply?  I was curious about the design of the power supply and had a few questions.  Note:  these are motivated merely by my curiosity and interest.  I have no real need to know.
> 
> For example, the KPA500 shows a block diagram of the amplifier & power supply and one of the voltage outputs is +270 and I was wondering what part of the amp circuit needs 270 volts, or 60 volts for that matter.
> 
> In idle mode, the HV display on my KPA500 reads 71 volts.  Thus, not 60 and not 270 volts.
> 
> Another question -- the other voltages from the supply are +5, -12, and +12.  I assume these are regulated voltages.  But, is the +60 and +270 regulated?  If these are regulated, what kind of voltage regulator is used.  I am likely ignorant and even possibly naive in this area as I have only used low-voltage regulator chips and so do not even know if HV regulator chips even exist (would they be stacked devices?).
> 
> End of questions for now.  Yes, a circuit diagram would answer all my questions.
> 
> 73, phil, K7PEH
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to phystad at mac.com