[Elecraft] K3 ALC

[Nr4c]

You’re sure to get Dons response to this.  But, it’s really the same as before. 

Using the USB cable for audio be sure to select USB AUDIO CODEC as sound device for both recording and playback. Now bring up the Windows mixer and set the level for playback (transmit) to about 30%. Now adjust the Line In (Mic Gain) to get 4 solid bars and fifth flickering. If the granularity is too coarse, set windows mixer level lower, maybe 20%. Try the radio again. I have set my Windows level quite low but get fine control with K3S Lime In Control. It is very stable and repeatable. As before, set Power with PWR knob on radio. 

Sent from my iPhone
...nr4c. bill


> On Mar 21, 2018, at 11:40 PM, Ed Hoeck <edkn3e at gmail.com> wrote:
> 
> Can someone tell me if  there is an instruction on how to set the ALC on a
> K3 with  the latest Elecraft sound card installed? The original manual was
> written B4 the internal sound card was an option. I am operating FT8 mode
> and it worked fine with my signal Link, but now I suspect that I am
> splattering. I am using the K3 in the data mode running about 35 watts.
> 
> Ed KN3E
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to nr4c at widomaker.com