[Elecraft] KAT500 commands

[Jack Brindle]

It is in the latest KAT500 Serial Command Reference, and requires V1.42 or later firmware in the KAT500.

Jack, W6FB

> On Mar 1, 2018, at 3:30 PM, Harlan Sherriff via Elecraft <elecraft at mailman.qth.net> wrote:
> 
> Thanks Dick, but I don’t see that command in either programmers reference manual. 
> 
> So Don, there is no way to programmatically know when the tuning has completed?
> 
> Sent from my iPhone
> 
>> On Mar 1, 2018, at 6:16 PM, Don Wilhelm <donwilh at embarqmail.com> wrote:
>> 
>> Harlan,
>> 
>> I don't believe that is available on a real time basis (which is what you apparently are seeking).
>> 
>> Yes, the K3 knows when the KAT500 has stopped tuning, but it is not available as a GET command.
>> 
>> 73,
>> Don W3FPR
>> 
>>> On 3/1/2018 6:02 PM, Harlan Sherriff via Elecraft wrote:
>>> Is there a GET command for either the K3 or KAT500 that will show when the tuner has completed a tune?
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to jackbrindle at me.com