[Elecraft] Filters

[Bill Frantz]

Congratulations. The K3 is a really nice radio with 
extraordinary factory support.

For SSB, I set low cut to .35 KHz and adjust the upper cut 
between 1.9 KHz and 2.8 KHz, depending on conditions. Higher 
makes for easier copy, but lower will eliminate more noise, and 
help with nearby stations. Remember, the crystal filters are to 
protect the AtoD converter in the receiver. The DSP has many 
useful settings between those of the installed filters.

73 Bill AE6JV

On 6/30/18 at 5:07 PM, 1lasportsman at cox.net (Bill) wrote:

>I recently purchased a K3 and trying to set up for SSB.I do not do code.
>Is there any recommended settings for the shift lo cut and width?
>It has the KFL3A-400 and the KFL3A-12.8 8 pole filters installed
>I have read the manual and it does not really help me.
>Thanks
>Bill
>W3WGG

---------------------------------------------------------------------------
Bill Frantz        | Re: Computer reliability, performance, and security:
408-356-8506       | The guy who *is* wearing a parachute is 
*not* the
www.pwpconsult.com | first to reach the ground.  - Terence Kelly