[Elecraft] k2 kit progress - Woops! Did I really do that?

Neil Zampella neilz at techie.com
Fri Jun 29 15:12:56 EDT 2018


Yep .. been there, .. done that ... waited for the replacement from 
California ... <sigh> ... and as Richard points out, finished mine with 
timely advice from Don.

FWIW .. its often faster to email to support at elecraft.com, as Don 
usually answers within a few hours or less.

Neil, KN3ILZ


On 6/29/2018 2:34 AM, Richard Smart wrote:
> Having done exactly the same thing (putting P1 on the wrong side of the board) my email to Elecraft support resulted in a very fast and helpful response.  A quick email should get you going again.
>
> Having completed the K2 now (with some very accurate and timely advice from Don W)- it was fun to build and is great to use especially in the field.
>
> Regards
>
> Richard S
> ZL4FZ
>
>
>
>> On 28/06/2018, at 13:00, Don Schroder <donanddeena at hotmail.com> wrote:
>>
>> Even a perfectionist can screw up now and then, right?
>>
>> I installed P1, a 20 pin male, right angle pin connector, to the RF board, on the FRONT side, when the instructions clearly state
>> “Position 20-pin male right-angle connector P1 on the bottom of the board.” Ok, I can deal with the whoop-see, just
>> DE solder, pull it out, and install a new right-angle connector. O’boy, DE solder trick didn’t go so well, P1 ended up in pieces.
>>
>> No problem, I have other right-angle pin connectors, just use them! But, after installing, the replacements are about 1/16” shorter
>> in length, and don’t go into J1 as far. Hello Huston, NOW we have a problem! The front panel is NOT getting any power!
>>
>> I need a new P1, part # E620029. Other than that, the build is going great! Do I need to send an email to Elecraft parts department?
>>
>> Comments are appreciated! Be kind, please, Thanks!
>>
>> Don, KE0PVQ  (thinking about a vanity call sign, suggestions?)
>>
>> Sent from Mail<https://go.microsoft.com/fwlink/?LinkId=550986> for Windows 10
>>
>>
>



More information about the Elecraft mailing list