[Elecraft] KPA500 and K3 SWR meters disagree

[jeff griffin]

Hi Jack. The swr is so different between the two that there has to be a
problem. I've had this setup for 3 years and never experienced this
behavior.

73 Jedff kb2m

-----Original Message-----
From: Jack Brindle [mailto:jackbrindle at me.com] 
Sent: Saturday, June 2, 2018 4:47 PM
To: jeff griffin
Cc: elecraft at mailman.qth.net
Subject: Re: [Elecraft] KPA500 and K3 SWR meters disagree

Jeff;

Do I understand that for the first test you are driving the antenna through
the KPA500 and KAT500 (with KAT500 in bypass)? If so, it makes a lot of
sense that you will see different SWR. The KPA and KAT are providing a
completely different load for the K3. The better test is to feed the antenna
directly from the K3 without the KPA and KAT in-line. I would expect you to
see a closer match at that point, although I doubt they will ever be
identical due to the differences in the directional couplers in the K3 vs
the KAT500 (and KPA500 for that matter).

Jack, W6FB


> On Jun 2, 2018, at 8:48 AM, jeff griffin <kb2m at arrl.net> wrote:
> 
> I recently brought my KPA/KAT500 north for the summer and hooked up to my
trapped multiband fan dipole that I use here in NJ. I leave my K3 here for
remote use and use the amp at my winter home in Florida to use with my Flex
6500 with a Steppir Vertical antenna without the KAT500 tuner. When I got up
here I installed the KIO3B option. The install went well with no issues, all
looked good so I connected the K3, P3, KAT500, and KPA500 with the Elecraft
provided cable set like I do every year. 
> 
> The issue I'm having is an SWR difference between the KAT500 and the K3.
For example if I use the K3's internal tuner I can on a chosen frequency
achieve an SWR of 1/1. I the put the internal K3 tuner in bypass mode and
take the KAT500 out of bypass and set to auto. I then use the xmit button on
the K3 to create a tune signal to be sent to the KAT500. The K3 then shows a
1/1, the KAT500 about the same but the KPA500 which is in STBY mode shows
around 3/1. What this causes to happen is the Amp will fault out if I try to
use any power output. If I check the antenna with a trusted SWR meter I see
1.3/1 at the frequency of use. I upgraded the firmware in all the devices in
use, I also did a reset of the KAT's stored frequencies memory, and checked
both the amp and tuner with the utility programs. I'm going to call Elecraft
on Monday, anyone have any ideas in the meantime I can try?
> 
> 73 Jeff kb2m   
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to jackbrindle at me.com