[Elecraft] KPA500 and K3 SWR meters disagree

[Don Wilhelm]

Jeff,

Check the coax between the KPA500 and the KAT500.  Make certain the 
connectors are tight.  Replace with a different coax if you have one.

You can always do a check on the KPA500 wattmeter by connecting a dummy 
load to the KPA500 (no tuner).

73,
Don W3FPR

On 6/2/2018 11:48 AM, jeff griffin wrote:
>   I recently brought my KPA/KAT500 north for the summer and hooked up to my trapped multiband fan dipole that I use here in NJ. I leave my K3 here for remote use and use the amp at my winter home in Florida to use with my Flex 6500 with a Steppir Vertical antenna without the KAT500 tuner. When I got up here I installed the KIO3B option. The install went well with no issues, all looked good so I connected the K3, P3, KAT500, and KPA500 with the Elecraft provided cable set like I do every year.
>    
>   The issue I'm having is an SWR difference between the KAT500 and the K3. For example if I use the K3's internal tuner I can on a chosen frequency achieve an SWR of 1/1. I the put the internal K3 tuner in bypass mode and take the KAT500 out of bypass and set to auto. I then use the xmit button on the K3 to create a tune signal to be sent to the KAT500. The K3 then shows a 1/1, the KAT500 about the same but the KPA500 which is in STBY mode shows around 3/1. What this causes to happen is the Amp will fault out if I try to use any power output. If I check the antenna with a trusted SWR meter I see 1.3/1 at the frequency of use. I upgraded the firmware in all the devices in use, I also did a reset of the KAT's stored frequencies memory, and checked both the amp and tuner with the utility programs. I'm going to call Elecraft on Monday, anyone have any ideas in the meantime I can try?
> 
> 73 Jeff kb2m
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to donwilh at embarqmail.com
>