[Elecraft] Keep getting BAT Err message

[Bob G3PJT]

Thanks very helpful. I just found the problem it was that the batteries were quite discharged and my charger PSU was a touch low in voltage. Seems OK now.
 
73 and thanks again
Bob G3PJT

Sent by Ipad


> On 31 May 2018, at 22:06, Don Wilhelm <donwilh at embarqmail.com> wrote:
> 
> Bob,
> 
> Read the BAT ERR description on page 4 of the KXBC3 manual.
> 
> You may have to remove the batteries and check the terminal voltage of each one with your DMM to determine if you have a bad one, or if all are possibly fully charged.
> 
> Reloading software will not make any difference, but likely will not hurt anything either.
> 
> 73,
> Don W3FPR
> 
>> On 5/31/2018 4:51 PM, Bob G3PJT wrote:
>> When I try to charge the battery I get Bat err message and charging is
>> terminated. I have reloaded s/ware etc but no change.