[Elecraft] BNC T for IF Out

[Nr4c]

Why not just use the IF OUT BNC jack on the P3 (right above the IF IN). And flip the small slide-switch up. 

Sent from my iPhone
...nr4c. bill


> On Jul 26, 2018, at 9:45 PM, John Simmons <jasimmons at pinewooddata.com> wrote:
> 
> You should use a splitter with isolation. Mini-Circuits sells them.
> 
> -John NI0K
> 
>> Leroy Buller <mailto:lee.buller at gmail.com>
>> Thursday, July 26, 2018 8:38 PM
>> Stupid Question of the Month.....
>> 
>> Is it possible to use a BNC T to drive P3 and a SDRPlay at the same time?
>> Is there enough drive to do this?
>> 
>> Back to your regular programming.
>> 
>> Lee K0WA
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>> 
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>> Message delivered to jasimmons at pinewooddata.com
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to nr4c at widomaker.com