[Elecraft] BNC T for IF Out

[Dave Fugleberg]

The P3 has an IF Out jack. I have connected that to a SDRPlay RSP1 with
good results. No splitter or tee required. You must flip the little switch
on the back of the P3 to enable IF Out.
On Thu, Jul 26, 2018 at 9:14 PM Leroy Buller <lee.buller at gmail.com> wrote:

> Part number?
>
> Lee
>
> On Thu, Jul 26, 2018, 8:45 PM John Simmons <jasimmons at pinewooddata.com>
> wrote:
>
> > You should use a splitter with isolation. Mini-Circuits sells them.
> >
> > -John NI0K
> >
> > Leroy Buller <lee.buller at gmail.com>
> > Thursday, July 26, 2018 8:38 PM
> > Stupid Question of the Month.....
> >
> > Is it possible to use a BNC T to drive P3 and a SDRPlay at the same time?
> > Is there enough drive to do this?
> >
> > Back to your regular programming.
> >
> > Lee K0WA
> > ______________________________________________________________
> > Elecraft mailing list
> > Home: http://mailman.qth.net/mailman/listinfo/elecraft
> > Help: http://mailman.qth.net/mmfaq.htm
> > Post: mailto:Elecraft at mailman.qth.net <Elecraft at mailman.qth.net>
> >
> > This list hosted by: http://www.qsl.net
> > Please help support this email list: http://www.qsl.net/donate.html
> > Message delivered to jasimmons at pinewooddata.com
> >
> >
> >
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to dave.w0zf at gmail.com
>