[Elecraft] The ProSet - K2 Boom Headset - Left channel only...

[Don Wilhelm]

Clay,


On your K3S, did you try plugging into the rear phones jack?  You can do 
that without any  1/8 inch to 1/4 inch adapter.

The resistance of each earpiece should be easy to check with your 
ohmmeter and be revealing if there is a cord problem.  The left channel 
(tip) should compare with the right (ring) unless something is open or 
shorted.

73,
Don W3FPR

On 7/24/2018 4:23 PM, Clay Autery wrote:
> Anyone ever had a ProSet two fail to deliver two channel output when 
> everything is set up correctly (aka bad cable or failed R channel solder 
> joint at one end or the other)?
> 
> My Elmer has a set bought in April of this year and has never been able 
> to get right channel.  I took it today to try on my K3s with known good 
> setup for 2-channel into phones (Sennheiser HD598SE).
> 
> Same problem on my radio...  no right channel.  Almost HAS to be 1) 
> solder joint failure on one of the wires to the driver, 2) a right 
> channel (+) solder failure at the 1/8" TRS, 2) failed right driver. It's 
> a non-coiled three cable-bonded cord...  so I am assuming 3 conductors 
> with shields for ground.
>