[Elecraft] SDRPlay connection to K3S

[Bob McGraw K4TAX]

Yes, you will need a Y cable, connect to RX ANT IN and OUT. The junction 
of the Y goes to the SDR Play.  To activate, press the RX ANT on the 
radio. This sends the ANT 1 or ANT 2 signal to the Out and then back to 
the In via the Y cable, while feeding same to the SDR play.

Works great.  I use HDSDR with OmniRig to control my K3S from the 
computer and if configured as such the SDR play follows the K3S.

In order to simplify a nest of cables and forgetting to push the RX ANT, 
I finally resorted to using the IF OUT to the SDR play. Again the HDSDR 
software allows configuring such that it tracks the K3S in all modes and 
frequencies.

73

Bob, K4TAX


On 7/17/2018 8:16 AM, Steve Muenich wrote:
> Hello gang,
>
> Is there a proper port on the K3S to connect a SDRPlay that would allow for sharing the main antenna while receiving, then be disconnected and isolated when the K3S go into transmit?
>
> Thanks
> Steve, NA5C
> K3S 10121
>
>
> Sent from my mobile device
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to rmcgraw at blomand.net
>