[Elecraft] W2 Sensor issue

[Bill Johnson]

I would suggest you may have a cable issue to test first. Try reconnecting the connectors.  And if you test at the site.  There are so many variables, we humans cannot help with being on site.  Take a few cell photos and then post to get help.

73,
Bill
K9YEQ

https://wrj-tech.com/

-----Original Message-----
From: elecraft-bounces at mailman.qth.net <elecraft-bounces at mailman.qth.net> On Behalf Of Michael Walker
Sent: Sunday, July 15, 2018 8:23 PM
To: Elecraft at mailman.qth.net
Subject: [Elecraft] W2 Sensor issue

I wonder if anyone has seen this before.

I was chasing a problem with high SWR on my 2K HF probe where on the radio, the antenna SWR reads 1.3:1 without the SWR probe installed and 2.9:1 with it installed.

Yes, I have changed my RG214 jumper cables to a few others.  I even replace the probe with a double female couple and the SWR dropped down to what I expected (about 1.3:1).

It is only on 6M that it has bad readings.   This is at my remote base, and
as I right this, I should have tested on a dummy load, but that will have to happen on my next trip.

So, as I asked before, anyone else see it fail only on 6m?

Mike va3mw
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html Message delivered to k9yeq at live.com