[Elecraft] New owner with New K3S kit need help?

[Don Wilhelm]

Glenn,

The errata sheets always supersedes the manual - it is the latest 
update/correction.  The designation on the errata title carries the 
manual designation that is to be corrected.
Go to the Documentation download page to be certain you have the latest.

73,
Don W3FPR

On 7/14/2018 10:41 AM, WA7SPY wrote:

> The K3S and options are all working. I had a problem with 2meters being off frequency after adding the K3EXREF and the K144XV reference board. I did a complete reset to factory defaults. I removed the K144XV reference board. Then set the 2 meter offset back to what was labeled on the module. The 2 meter frequency was accurate. I put the K144XV reference board back in. Now the 2 meter frequency is accurate with the board back in. My question is where is the TMP cable suppose to be connected on the KSYN3 board? I have one end connected to REF IN on the 2 meter module. I initially connected the other end to J4 on the KSYN3. I now have it connected to J1 on the KSYN3 do I have the TMP cable connected correctly? The documentation is a little confusing to me. Figure 13 page 15 on the K3EXREF manual shows J4 being used on the KSYN3A if both the KXV144 reference board and the KEXREF options are installed. There is an Errata sheet showing to use J1 on the KSYN3 board. Which one is cor
>   rect to use for my set up J1 or J4?
> The K3EXREF is working with very accurate frequency on the HF bands with my GPS 10 MHz disciplined oscillator clock  connected. The 2 meter frequency was off when connected to J4. I am not sure if it was corrupt software and doing the reset corrected the issue and am uncertain where to connect to on the KSYN3A board?