[Elecraft] RF Meter Doesn’t Move when radio set to 10 watts

[usmcss]

Been trying to figure out why every once in a while “Ext. Mic” will display
on the screen when transmitting. I’m working with Elecraft on it currently.

My question is; does anyone notice when you have the radio set to 10 Watts
the RF meter only shows on bar? When I set the radio below 9.8 watts the
meter always works fine.

I can adjust the mic gain up and down while set at 10 watts and the RF meter
will start moving again. Even when I put it back on the mic gain setting
that it wasn’t working on. But when I turn the radio off and back on the RF
meter doesn’t move unless I’m under 9.8 Watts? 

Even if I get the RF meter to start moving again when I adjust the mic
control, if I wait a little while it will stop moving. It does it with the
internal mic as well.

And just to be clear, this is happening when I push PTT and talk into mic.

Anyone have any idea on this? If you could check your radio I would
appreciate it.

Thank you!!!



--
Sent from: http://elecraft.365791.n2.nabble.com/