[Elecraft] Subreceiver Installation Suggestions

[Grant Youngman]

Unless you have a specific application, I’d just use the default antenna routing configuration.

And be careful when you drop it in. I’ve had my sub-receiver box in and out quite a few times over the years for one reason or another.  Not long ago I discovered it wasn’t working (?).  Dead as a doorknob.  Discovered that when I put it in the connector block on the side nearest the front of the radio I had pinched a coax cable, and pulled it out of its socket.  Never saw it … dumb as a brick ;-)

It’s also not a bad idea (not sure if it’s in the instructions or not) to remove the left side panel (looking at the radio from the front) so you can see the rear connector.  It makes it a bit easier to see the pins and get them properly lined up and seated.

Grant NQ5T
K3 #2091, KX3 #8342

> On Jul 5, 2018, at 12:21 PM, Lee Murrah via Elecraft <elecraft at mailman.qth.net> wrote:
> 
> I recently purchased the subreceiver for the K3S.  Before I install it, it there anything I should know or think about?  I think there is a choice of antennas. Is there anything else I should do now that would be harder to do after the installation?
>