[Elecraft] Low Voltage Band Data Output

[William Liporace]

OK, the answer was to put a lower resistor in the input.
All I needed was 100 ohm jumper.

Will WC2L


On 7/4/2018 3:55 PM, William Liporace wrote:
>
> I really should have said antenna switch controller. I have two 
> controllers.
> A) Is the DX Solutions SAS-6 (Smart Antenna Switch-6)
> B) The KK1L 2x6 Controller.
> Both devices worked flawlessly from the FTdx5000.
>
> Will WC2L
>
> On 7/4/2018 11:55 AM, William Liporace wrote:
>> Hi Folks,
>> I thought it was me, but I guess not... When I hook up a cable to the 
>> ACC plug for band data output, I get about 4.8v (slightly less than 
>> 5v). When I hook up the radio to any antenna switch that has band 
>> data input, the voltage goes down to 3v. This is not enough to drive 
>> the antenna switches.  This is a new KIO3B board, so is it a bad 
>> board? Is there something else not set right that I am missing?? I 
>> didn't anything in the manuals..
>>
>> TNX Will WC2L 
> -- 
> William Liporace WC2L
> http://www.wc2l.com  orhttp://dxc.wc2l.com
> AR-Cluster Node  telnet dxc.wc2l.com or 144.93 MHz
> wc2l at wc2l.com

-- 
William Liporace WC2L
http://www.wc2l.com or http://dxc.wc2l.com
AR-Cluster Node  telnet dxc.wc2l.com or 144.93 MHz
wc2l at wc2l.com