[Elecraft] Low Voltage Band Data Output

[William Liporace]

Hi Folks,
I thought it was me, but I guess not... When I hook up a cable to the 
ACC plug for band data output, I get about 4.8v (slightly less than 5v). 
When I hook up the radio to any antenna switch that has band data input, 
the voltage goes down to 3v. This is not enough to drive the antenna 
switches.  This is a new KIO3B board, so is it a bad board? Is there 
something else not set right that I am missing?? I didn't anything in 
the manuals..

TNX Will WC2L

-- 
William Liporace WC2L
http://www.wc2l.com or http://dxc.wc2l.com
AR-Cluster Node  telnet dxc.wc2l.com or 144.93 MHz
wc2l at wc2l.com