[Elecraft] K2 encoder subassembly issue

[Don Schroder]

Hi folks!

Had another whoopsie with my K2 Serial #7818. Number 4 wire, that attaches the encoder subassembly to the front panel, had a soldering pad disintegrate. I found this when I
was testing, and saw that the encoder was not changing the frequency up or down. I am assuming that the wire not being soldered would cause the encoder to fail the test.

I’ve had my kit together and apart multiple times now. I may have caused the malfunction by separating the boards too many times? Regardless, I’ve contacted Elecraft Parts
and requested a new encoder subassembly PCB. Hope I can get just the board and not have to buy a whole subassembly!

Other than that issue, I’m thrilled with my kit, and excited to continue populating the RF board. Do you think I should continue, or should I wait for the new PCB and complete
the testing before continuing? I guess that is one of those “Are we there, yet?” questions!

Don,KE0PVQ

Sent from Mail<https://go.microsoft.com/fwlink/?LinkId=550986> for Windows 10