[Elecraft] P3 help needed

[eric norris]

I disconnected my P3 #24x from K3 #2545, and connected it to K3S #11xxx, using a bnc cable, and the elecraft cable that goes from the TRANSCEIVER jack on the p3, to the ethernet jack on the  K3S.  All firmware is the latest.  The K3S is connected to the PC via the K3S USB port.
The P3 worked fine with the K3.
Now, with the K3 S, it is showing the frequency of signals LOW, outside the green passband.even.  It won't show where VFO B is anymore, and when I set mrkr a or mrkr b, they are also off frequency.
What am I doing wrong?
Please reply direct--I'm in Digest mode, and need to fix this ASAP.
THANK YOU ES
73 Eric WD6DBM

Sent from Yahoo Mail on Android