[Elecraft] Elecraft KIO3B and WSJT-X

[Dave S]

I tried starting 10 first then X and it didn't seem to help.Yes, the audio config is the same in both programs.I turned off CAT but once again it didn't help.
I asked Elecraft tech support about it but they had not heard of another case and could offer no help. 

    On Saturday, January 6, 2018 12:49 PM, Josh <josh at voodoolab.com> wrote:
 

 That's really odd! It's quiet until the program starts?

What happens if you run 10 and X concurrently? Start up 10 first, it's quiet, then start X?

Audio config on X is identical to 10?

HA!! Try turning off CAT control in WSJT-X. I bet the program is changing something on the rig to make the noise come up. 

73,
Josh W6XU

Sent from my mobile device

> On Jan 6, 2018, at 11:35 AM, Dave S via Elecraft <elecraft at mailman.qth.net> wrote:
> 
> After I installed the KIO3B board in my K3, I found that running WSJT-X creates 2 or 3 S-units of noise in the rig but WSJT 10 runs quietly.Tried different computers, different cables, different jacks, and scads of ferrites on the USB cable. Nothing seems to help.Has anyone else run into this problem?
> Dave W7OJT
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to josh at voodoolab.com