[Elecraft] P3 minor bug in firmware ??

[ANDY NEHAN]

I have a P3 with latest revision of firmware and an SVGA
card and a station monitor and a USB keyboard plugged in as well.
The frequency readout on the P3 and external monitor is
correct under all common operating situation when I have a “span” of, say 100KHz. However, when I use the command sequence:-
#CTF00000000000;#SPN00040;RCF+002000 which gives a span of
4KHz, centres the frequency and then effectively moves the filter area to the
left there is a small problem. If I set the dial to 7.100KHz then apply the above
command string (via a stored macro accessed via the USB keyboard) then the
reading on BOTH the SVGA connected monitor and the P3 itself stow
7.100.0 at the left 7.100.00 middle and 7.104 at the right
edge. Clearly this is not correct. 
Thoughts and observations welcomed.
 
G4HUE, Andy