[Elecraft] Fwd: K3 And WSJT-X FT8 Timing

[RIchard Williams]

 When setting up radio settings in WSJT-X for the K3/K3S, I keep seeing different settings for the number of stop bits (one and two) popping up on the reflector.    Am not sure where TWO stop bits is coming from???  On page 20 of the K3S manual (page 18 of the K3 manual), left hand column, Serial Port Setup,  it states "Software should be set up at the same rate: 8 data bits, no parity, 1 stop bit".
Have no idea why the Radio set window in WSJT-X defaults to TWO stop bits when you select Elecraft K3/K3S.   Initially, I did not catch this, and I was encountering problems with my K3S remaining in transmit mode more often than not after a transmission.  Once I changed to ONE stop bit, my problem magically went away.

What I have set up is:
Rig: Elecraft K3/K3S , Polling interval: 1sec
CAT control: COM 13 (which is a virtual com port set up with LP-Bridge with my setup, your setting will be whatever com port are using).
Baud rate: 38,400
Data Bits, Stop Bits, and Handshake:  8, none, 1.
PTT method: CAT
Mode: Data/Pkt
Split Operation:  Rig

DIck, K8ZTT