[Elecraft] KPA1500 Utility

[Rick WA6NHC]

Thank you for the fast response.

In another email thread, I'm proposing a network interface for the K3 
(with audio) that plugs into the same connector as the K-pod (but would 
need an audio section as well for older KIO boards), which would make 
the entire K-line network available; therefore (with some software 
updates for management) much easier to remote without a computer to 
manage the station.

Rick


On 2/21/2018 1:06 PM, Dick Dievendorff wrote:
> This is planned for the next utility rev. Static IP was just recently added to firmware.
>
> 73 de Dick, K6KR
>
>
> Sent from my iPhone
>
>> On Feb 21, 2018, at 12:37, Rick WA6NHC <wa6nhc at gmail.com> wrote:
>>
>> Hello,
>>
>> I normally run the KAT500 and KPA500 utilities on the computer than manages my station.
>>
>> I'm awaiting the arrival of the KPA1500 but in the meantime I read the manual and download/installed the KPA1500 utility, which leads me to a request.
>>
>> In one of the next utility iterations, could it include a network interface made within the utility program so that instead of a serial port, the network connector could be used?
>>
>> Thank you,
>> Rick WA6NHC
>>
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>>
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>> Message delivered to dick at elecraft.com