[Elecraft] KAT500/KPA500 with Icom 7600 accessory cable

[Jim Brown]

That's not nearly enough.  EVERYTHING in your home must be bonded 
together -- power, telco, CATV, your antennas, and all ground rods.  Two 
places to learn it -- N0AX's recent ARRL book on grounding and bonding, 
and my own tutorial, upon which much of Ward's book is based.

http://k9yc.com/GroundingAndAudio.pdf

Also -- as noted in my tutorial, EVERYTHING connected with your station, 
including computers and other accessories connected to your rig) should 
get power from the same outlet, or from outlets whose green wires (third 
pin) are bonded together in your shack. This is just as important as 
bonding.

73, Jim K9YC

On 12/30/2018 4:13 PM, Ken B via Elecraft wrote:
> Good evening  The Icom IC-7600 KAT500, and KPA500 are each grounded to a single terminal strip with a #10 cable directly to a ground rod 15 ft away. The rod is 12 ft deep. Both the KAP and KTA were factory built as my soldering skills have diminished since the Army training.