[Elecraft] How to wire KX3 to an Amp

[Mark Goldberg]

Are you going to use the KX3, KXPA100 and the KPA500 all together? I can't
help with that as I don't have the KXPA100.

I use the KX3 with just the KPA500. You get about 250W out with 12W in.

You use the ACC2IO cable that comes in the right angle cable kit or
standalone and an RCA to RCA cable.
https://elecraft.com/products/kx3-pckt-accessory-cable-kit
https://elecraft.com/products/e980232_acc2-io-cable-module-config-via-kx3s-acc2-io-menu-item-included-in-the-kx3-pckt-cable-set

It picks up the frequency with the first dit or a small carrier. Hope this
helps or someone else pipes up if you want to use all three together.

73,

Mark
W7MLG



On Thu, Dec 20, 2018 at 1:21 PM John Pierce <ja-pierce at verizon.net> wrote:

> I recently purchased a KPA500 with the cable to connect to the KX3.   Can
> someone tell me where the plugs on cable that connects the  KPA100 amp plug
> into the KX3?  I have been told that that cable can be used to connect to
> the KPA500 without the frequency control.
>
>
>
> John
>
> Ad2F
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to marklgoldberg at gmail.com
>