[Elecraft] k3 High Current Message on 10 meters

[Don Wilhelm]

Harv,

I did not see the initial post (fault of Nabble vs. the real Elecraft 
reflector), but High Current messages can be caused by a low impedance 
at the antenna connection, or also a fault in the KPA3, like one output 
transistor that is no longer functioning properly.
There are other causes, like incorrect bias to the PA transistors.
Without more specific observations, it is difficult to give a specific 
answer.

Have you tried a TX Gain Calibration on your K3/K3S?  If not, try it.

73,
Don W3FPR

On 12/19/2018 9:30 AM, Bob Harvey - K2PI wrote:
> John did you ever get an answer to this?  I have a similar situation.
> 
> 73
> Harv
> K2PI
> 
> 
> 
> --
> Sent from: http://elecraft.365791.n2.nabble.com/
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to donwilh at embarqmail.com
>