[Elecraft] [K3] - Hum on SSB Transmissions

[Joe Rogers]

Hi Don,

You hit upon exactly what I did!!  When I last did on air checks, I had the Proset in the rear panel jack and had same hum as in front panel - which, as you pointed out, would indicate that the adapter was not the problem and the issue is in the Proset itself.

I am pretty much convinced it is in the Proset IC now.  I just cannot understand why after only about a year, I have this failure.  My prior Proset was 6 years old and no problem.  Anyway, I am talking to Heil and hope to get the whole issue sorted out.

73
Joe AJ1Y


-----Original Message-----
From: Don Wilhelm <donwilh at embarqmail.com> 
Sent: Tuesday, December 4, 2018 10:48
To: Joe Rogers <jerogersesq at hotmail.com>; elecraft at mailman.qth.net
Subject: Re: [Elecraft] [K3] - Hum on SSB Transmissions

Joe,

If you are using the Front Panel adapter for the ProSet-Ic, try plugging the microphone into the MIC jack in the back of the K3 and changing the MIC SEL menu to the rear panel.
If the hum is not present, then you have a bad adapter instead of a bad mic.

73,
Don W3FPR


On 12/4/2018 10:32 AM, Joe Rogers wrote:
> Hi Don,
>
> Thanks for the email suggestions.
>
> I ran some on air checks of the Proset and the other mike I have - a Gold Elite.  Gold Elite audio was fine.  Proset was poor.  Believe it is the open microphone ground lead problem that you mentioned.
>
> Thanks,
>
> 73
> Joe AJ1Y
>
>
> -----Original Message-----
> From: Don Wilhelm <donwilh at embarqmail.com>
> Sent: Monday, December 3, 2018 19:44
> To: Joe Rogers <jerogersesq at hotmail.com>; elecraft at mailman.qth.net
> Subject: Re: [Elecraft] [K3] - Hum on SSB Transmissions
>
> Joe,
>
> Do you hear that hum when you operate into a dummy load?  If not, then check the common mode choke on the antenna, you are likely getting RF-In-the-Shack from the antenna - the fact that it diminishes when you put your hand on the K3 amplifies that this may be the problem.  Forget about grounding the radio for this problem, solve it at the antenna feedpoint with a good common mode choke on the feedline.
>
> Other possibilities are power supply ripple (run it on battery to check) or an open microphone ground lead (try other microphones).
> Make sure the rear panel jacks are fully plugged (give them an extra push).
>
> 73,
> Don W3FPR
>
> On 12/2/2018 4:17 PM, Joe Rogers wrote:
>> I normally operate CW but the other day and have not been SSB for a few weeks to a month.  Yesterday, I was getting ready to operate SSB and I noted a hum through the monitor when I key the transmitter. By way of background, K3 is 2012 vintage and I assembled the kit.  No problems with until this one.  I have found several similar threads mentioning a hum on SSB transmit but of the mentioned solutions worked to solve my problem.
>>
>> I have Heil Pro set IC and Heil Gold Elite.  The problem seems much more pronounced with Proset IC.
>>
>> Whether it is connected to front panel (FP.H or RP.H Bias on) makes no difference.  If I used PTT or VOX it is there.  Set Mic Gain at anything above zero it starts.  With higher mic gain and higher compression it is worse.   I have made some PSK contacts using the LIN IN input and seems to work OK.
>>