[Elecraft] KPA-1500 PSU mounting position

[Don Wilhelm]

Peter,

If you mount the KPA1500 power supply vertically, put it on the front 
panel and there will be no interference with the air flow.
Note that the LEDs stick out a bit from the front panel, so put the 
large part of the front panel on something that will be as thick or 
thicker than the amount the LEDs project - like a piece of wood or plastic.

73,
Don W3FPR

On 8/20/2018 12:09 AM, Peter Dougherty wrote:
> Hi All,
> My KPA-1500 arrived over the weekend and I've not gotten a chance yet to set it
> up. In looking at both the amp and the power supply I noticed both have carrying
> handles and rubber feet. Are these rubber feet just there for transporting the
> untis, or can the power supply actually be run vertically with equal efficiency
> and cooling as it would be horizontally? If so, that would fit my operating desk
> perfectly.