[Elecraft] K3 No power out

[Bob Wilson, N6TV]

>From the "Troubleshooting" section of the K3 manual:

*No power output*: You may have routed RF through the KXV3’s XVTR IN/OUT
jacks, either by switching
to a transverter band, or by setting CONFIG:KXV3 to TEST. Also try redoing
TX GAIN cal (pg. 49).

73,
Bob, N6TV

On Tue, Aug 14, 2018 at 9:29 PM, Don Roberts via Elecraft <
elecraft at mailman.qth.net> wrote:

> Yes I can set it at 35 watts which is what I usually use to drive the KPA
> 500, and speak in the mic for ssb and get no power out. In cw at the same
> 35 watts, when I send code either straight key or padfle. 0 watts out. Same
> results if I attempt to run bearfoot at 100 watts or 5 watts, I get no
> power out. Receive is working fine, the P3 is working normal, and the KPA
> 500 and KAT 500 track bands as I change them.
> I will try again tomorrow after a night of sleep. If still no go, will
> phone home to Elecraft
> Don, W4CBS