[Elecraft] K3 No power out

[David Bunte]

Don -

If this was suggested before, I missed it and apologize for the redundancy.
Has the rig inadvertently been put into the test mode? If the TX indicator
under the VFO A box is blinking, that would explain the symptoms.

Dave - K9FN

On Wed, Aug 15, 2018 at 12:30 AM Don Roberts via Elecraft <
elecraft at mailman.qth.net> wrote:

> Yes I can set it at 35 watts which is what I usually use to drive the KPA
> 500, and speak in the mic for ssb and get no power out. In cw at the same
> 35 watts, when I send code either straight key or padfle. 0 watts out. Same
> results if I attempt to run bearfoot at 100 watts or 5 watts, I get no
> power out. Receive is working fine, the P3 is working normal, and the KPA
> 500 and KAT 500 track bands as I change them.
> I will try again tomorrow after a night of sleep. If still no go, will
> phone home to Elecraft
> Don, W4CBS
>
> Sent from Yahoo Mail on Android
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to dpbunte at gmail.com
>