[Elecraft] K3 No power out

[Dennis Moore]

"No power to tune anything." Does this mean you've only tried to tune, 
and haven't tried actually transmitting cw or phone? If so, and I don't 
know how it would have changed, have you checked the Menu-Config-TUN PWR 
to see what it is set to? If it is set to .1 it will show 0.0

73, Dennis NJ6G


On 8/14/2018 17:19, Don Roberts via Elecraft wrote:
> I have enjoyed the wisdom of this group and have learned so much but now it is my time to ask for help. My K3 is showing no power out. I have the K line. The relay clicks when going from 11 to 12 watts. I can set the power up to 110, but when I hit tune I get zere watts shown and verified by my watt meters. Makes no difference of mode, band, dummy load, resonant ant, or multiband hex beam, 80 meter horizontal loop, or 40 meter vertical. There is no output to tune anything.
> My last contacts showed no problems. Worked 10 meter cw, 20 and 6 meter ssb ok just two days ago.  It seems to be receiving fine. The P3 display is normal, the KAT 500 and KPA 500 change bands with the K3 as they normally do. I have rebooted the K3 several times and have killed the master AC power to everything only to bring it up to the same thing. The ALC, compression, mic gain all register correct, where I always run them. I have checked to make sure the Test button has not been ingaged. Press XMIT and all I get is 0 W.  I am sure I have forgotten something simple. Would appreciate any help.  Thanks
> 73, Don W4CBS