[Elecraft] KAT500 memories

[Brian D]

Are the segments on fixed frequencies? I like to work through the bands I
use before contests to set up tuning. Sometimes in the following contest I
find a frequency which seems to be between segments, retuning within 10KHz
either side doesn't then seem to correct the tuning on the specific
frequency I want to use.


Don Wilhelm <donwilh at embarqmail.com> wrote:

> Harlan,
> 
> There are enough to store data for each band segment in the 160m thru 6m
> bands.  Page 15 of the KAT500 manual shows the width of each band
> segments:  Below 3 MHz the segments are 10 kHz wide.  From 3 MHz through
> 26 MHz the segments are 20 kHz wide.  From 26 MHz to 38 MHz the segments
> are 100 kHz wide.  From 38 MHz to 60 MHz the segments are 200 kHz wide.
> 
> You are not likely to run out of memories.
> 
> 73, Don W3FPR
> 
> On 4/24/2018 3:07 PM, Harlan Sherriff via Elecraft wrote:
> > I understand the tuner holds tune data in memories for quicker tuning
> > when changing frequencies, and it stores separate data for each antenna
> > port. My question is, how many data points can these memories hold? In
> > other words, how many frequencies per band per antenna can it hold?
> ______________________________________________________________ Elecraft
> mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help:
> http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net Please help support this email
> list: http://www.qsl.net/donate.html Message delivered to
> groups at planet3.freeuk.co.uk
> 


-- 
Brian D
G3VGZ  Yarm    England