[Elecraft] Firmware Update TM Command

[Bob McGraw K4TAX]

I tried it via the Utility Command test.   It is for computer functions and not in the Radio Menu  or Config Menu.  


Bob, K4TAX


Sent from my iPhone

> On Apr 2, 2018, at 9:40 PM, Rich <rwnewbould at comcast.net> wrote:
> 
> I think it is a computer command, not a menu/config setting.   At least I think so?
> 
> Rich
> 
> K3RWN
> 
> 
>> On 4/2/2018 22:05 PM, Bob McGraw K4TAX wrote:
>> Is this feature new or unique to the K3 but has been resident for the K3S?   If not, I haven't found the TM command in either the Menu or Config of my K3S.
>> 
>> 73
>> 
>> Bob, K4TAX
>> 
>> K3S  S/N 10163
>> 
>> 
>> Firmware update
>> 
>> K3 MCU 5.62 / DSP 2.88 / FPF 1.26, 11-16-2017
>> 
>> * NEW CONTROL COMMAND (TM):  The TM command sets or reads the transmit metering mode on the LCD. TM0; sets the bar graph for SWR/RF, while TM1; sets the bar graph for CMP/ALC. The TX metering mode also determines what is read by the BG (bar graph read) command during transmit. With TM0 in effect, BG reads the power level. If TM1 is in effect, BG reads the ALC level.
>> 
>> 
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>> 
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>> Message delivered to rwnewbould at comcast.net
> 
>